OVERVIEW
The ULT-3000 contains all of the functions required for studying and experimenting with analog electronics, digital electronics, telecommunication electronics etc. The ULT-3000 is a complete analog and digital training platform which is compact, lightweight and extremely durable.
APPLICATIONS
- Basic Electronics Training Courses
- Advanced Electronics Circuit Design
- Analog Circuit Experiments
- Digital Circuit Experiments
- Telecommunication Circuit Experiments
- Basic Logical Circuit Tracing
- Computer Interfacing Circuits
- Circuit Trouble Shooting
SPECIFICATIONS
1. DC Power Supplies Module
Fixed Output: +5V/1A, -5V/1A, +12V/0.5A, -12V/0.5A
Variable Output: +0V ~ +24V/1A, -0V ~ -24V/1A
All power supplies are short circuit protected
2. AC Power Supplies Module
19V–15V–9V–0V–9V–15V-19V
3. Function Generator (2 Channels) & Clock Generator (2 Channels) Modules
Sine, Triangle and Square waveform output
Frequency range: 1Hz to 1MHz in 6 decades
With fine adjust, Amplitude and DC offset control
Clock output 1Hz to 1MHz in 6 decades
Six frequency ranges:
1Hz to 10Hz
10Hz to 100Hz
100Hz to 1KHz
1KHz to 10KHz
10KHz to 100KHz
100KHz to 500KHz
Sine wave output: 0 to 12V peak to peak variable
Triangle wave output: 0 to 8V peak to peak variable
Square wave output: 0 to 22V peak to peak variable
4. Solderless Breadboard Module
Interconnected nickel plated with a total of 1860 tie points nickel plated contact, fitted all DIP sizes and all components with lead and solid wire in diameter of AWG #22-30 (0.3-0.8mm)
5. Two Pulse Switches Module
80uS Single Shot Pulse (Positive & Negative)
2 units push button switch contain switches debouncer for eliminating the bounce caused by switch from “open” to “close” or from “close “ to “open” position.
6. Two digits 7-segment LED Display Module
Numerical designs and resultant display Truth Table
7. 16-Bits LED Indicators with buffer Module
Sixteen LED’s separate input terminals in three colors. (RED, Yellow & Green). The LED will be lighted up when input is at “HI Level”, and it will be turned off when it is at no input or at “LO Level”. Capable for Traffic Light Experiments.
8. 16-Bits HI/LO Data Output Switches Module
16 units slide switches and corresponding output terminals. When switch is set at “down” position, the output is LO level; contrarily, it is to be HI level when setting at “up” position.
9. TTL/CMOS Selection Switch
Select TTL or CMOS Mode for data switches
10. 3-State Logic Probe Module
HI, LO, FLOAT 3 Logic Level Testing
CMOS / TTL Level Selection
11. Speaker Module
8Ohm, 0.25W With Buffer
12. Digital DC Volt Meter Module
4 Digits LED display
Four voltage ranges:
0V to 199.9VDC
0V to 19.99VDC
0V to 1.999VDC
0V to 199.9mVDC
Input Impedance: 10Mohm for any range
13. Adaptors Module
5 Channels Banana to 2mm Adaptor Interface Socket and turn pins sockets
14. Universal Connector Fixed Holder Module (Optional)
It reserves universal connector fixed holder on the panel in order to be connected with various universal connectors, which are available listed as follows:
UC-01: Straight Header 60 pin
UC-02: Card Edge Connector 2.54mm 62 Pin
UC-03: Card Edge Connector 3.96mm 28 Pin
UC-04: RS-232 Connector 25 pin D-Sub Connector (Male & Female)
UC-05: USB Connectors
UC-06: Centronics / Parallel 2.54mm 36 Pin
The ULT-3000 is shipped with a comprehensive CD Format Experiments Manual, Instruction Manual with Self Maintenance Guide and a power cord.
Power Supply : 240VAC, 50Hz (Fused Protected)
Dimensions : (W x D x H) 310 x 260 x 90mm
Weight : 3.5 kgs
